CÔNG TY CỔ PHẦN ĐẦU TƯ HOÀNG ĐẠO (ZODIAC)
Trụ sở chính : Tầng 11, Tòa nhà Zodiac, phố Duy Tân, phường Dịch Vọng Hậu, Cầu Giấy, Hà Nội
Điện thoại: (04) 3514 6555 - Fax: (04) 3514 7078
E-mail : cskh@zodiac.com.vn
Website: http://zodiac.com.vn/

Bộ phát tín hiệu DVI, âm thanh, RS232 trên cáp sợi quang FOXBOX Tx DVI Plus
Giá bán lẻ: 0 VNĐ

Mô tả

Bộ phát tín hiệu DVI, âm thanh, RS232 trên cáp sợi quang (Fiber Optic Transmitter for HDMI, Audio, and RS-232)
In báo giá

Thông số kỹ thuật

FOXBOX Tx DVI Plus
 NOTE     The FOXBOX Tx DVI Plus transmitter is compatible only with the following receivers:
FOXBOX Rx DVI Plus, PowerCage FOX Rx DVI Plus board, FOXBOX Rx HDMI, PowerCage FOX Rx HDMI board, FOXBOX SR HDMI, and PowerCage FOX SR HDMI board.
 NOTE     The analog audio signals are digitized in the transmitter, sent through the fiber cable, and converted back to analog audio in the receiver.
 NOTE     This transmitter is a class 1 laser product. It meets the safety regulations of IEC-60825, FDA 21 CFR 1040.10, and FDA 21 CFR 1040.11.
 
Optical fiber interconnection between transmitter and receiver
   Number/type  1 or 2 fiber optic
    NOTE     Only one fiber is required to transmit video, audio, and unidirectional data. A second fiber is required to transmit return data for bidirectional control/communication.
   Connectors  2 LC connectors
   Operating distance   
      Singlemode  30 km (18.75 miles) with singlemode (SM) cables with a FOXBOX SM
      Multimode  300 m (985') with 62.5 µm OM1 multimode (MM) cables with a FOXBOX MM
1 km (3280') with 50 µm OM2 multimode (MM) cables with a FOXBOX MM
2 km (6561') with 50 µm OM3/OM4 2000 MHz bandwidth laser optimized multimode cable with a FOXBOX MM
    NOTE     Operating distance is approximate. These are typical maximum distances that may vary depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks.
   Nominal peak wavelength  850 nm for FOXBOX MM, 1310 nm for FOXBOX SM
   Data rate  4.25 Gbps
   Transmission power  -5 dBm, typical
   Maximum receiver sensitivity   
      Singlemode  -18 dBm, typical
      Multimode  -12 dBm, typical
   Optical loss budget   
      Singlemode  13 dB, maximum
      Multimode  7 dB, maximum
 
Video
    NOTE     *Appropriate DVI-D to HDMI cables or adapters are required for HDMI signal input/output. The FOXBOX DVI Plus Series can be used to distribute HDMI signals if you use a DVI-to-HDMI adapter. However, when HDMI signals are used, these units do not transmit audio and CEC signals.
The FOXBOX DVI Plus does not support transmission of DVI signals with High-bandwidth Digital Content Protection (HDCP).
   Resolution range  Up to 1920x1200 or 1080p @ 60 Hz pixel for pixel
   Formats  RGB and YCbCr digital video
   Standards  DVI 1.0, HDMI
 
Video input
   Number/signal type  1 single link DVI-D (or HDMI*)
   Connectors  1 female DVI-I
 
Audio
   Gain   
      Range  Adjustable, -18 dB to +10 dB
      Default  Unbalanced output: 0 dB
   Frequency response  20 Hz to 20 kHz, ±0.5 dB
   THD + Noise  0.10% @ 1 kHz at nominal level
   S/N  >80 dB at maximum output (unweighted)
   Audio bits per sample  18 bits per channel, 2 channels (L, R)
   Sampling rate  48 kHz
 
Audio input
   Number/signal type  1 unbalanced stereo or 2 unbalanced mono
   Connectors  (1) 3.5 mm mini stereo jack
   Impedance  18k ohms unbalanced, DC coupled
   Nominal level  -10 dBV (316 mVrms)
   Maximum level  +8.9 dBV, (unbalanced) at 1% THD+N
    NOTE     0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
 
Control/remote
   Serial control ports
      Control  1 RS-232, 2.5 mm mini stereo jack (front panel)
      Pass-through  1 RS-232, 3.5 mm captive screw connector, 5-pole (3 pins are used) (rear panel)
   Baud rate and protocol   
      Control  9600 baud, 8 data bits, 1 stop bit, no parity
      Pass-through  9600 to 115,200 baud
   Serial control pin configuration  Mini stereo jack: tip = Tx, ring = Rx, sleeve = GND
   Program control  Extron control/configuration program for Windows®
Extron Simple Instruction Set (SIS)
 
General
   Power supply  External
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A, 12 watts
   Power input requirements  12 VDC, 0.6 A
   Temperature/humidity  Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
   Cooling  Convection, vents on top and side panels
   Thermal dissipation  4.0 BTU/hr
   Mounting   
      Rack mount  Yes, with optional rack shelf
      Furniture mount  Yes, with optional under desk mounting kit
   Enclosure type  metal
   Enclosure dimensions  1.0" H x 4.3" W x 6.0" D (quarter rack wide)
(2.5 cm H x 10.9 cm W x 15.2 cm D)
(Depth excludes connectors.)
   Product weight  0.7 lbs (0.3 kg) per unit, 1.4 lbs (0.6 kg) per pair
   Shipping weight  3 lbs (2 kg) per unit, 6 lbs (3 kg) per pair
   Vibration  ISTA 1A in carton (International Safe Transit Association)
   Regulatory compliance   
      Safety  CE, c-UL, FDA Class 1, UL
      EMI/EMC  CE, C-tick, FCC Class A, ICES, VCCI
   Warranty  3 years parts and labor
    NOTE     All nominal levels are at ±10%.
    NOTE     Specifications are subject to change without notice.